How to remove the table saw blade

Removing the blade on a table saw is one of the most routine actions I perform during a project. It is important to use the correct blade for the task. If I am cross cutting, ripping or using the dado I make sure the correct blade is installed and adjusted.

• First unplug the table saw and make sure you can see the plug while you work.
• Second remove the table top cover that surrounds the blade and prevents small pieces from falling through the table.
  
• Third place a scrap piece of wood through the table so that it catches the teeth of the blade. This is so that the blade doesn't accidentally spin while you are using the wrench.
• Fourth use a wrench to loosen the bolt that holds the blade on. The trick with this bolt is that it is not "righty tighty, loosy lefty", so make sure to loosen it in the opposite direction as you normally would.
• Finally remove the bolt and washer from the saw blade and then carefully slip the blade off.

It usually takes me a few minutes to safely remove a table saw blade. It is important to not rush these steps. Always make sure the saw is unplugged.